High-intensity Discharge (HID), a lighting technology that uses xenon gas as the light conductive medium, to obtain a higher light intensity. HID lamps have a light intensity of 20-30% more light than standard lamps (with a smaller power consumption) are still using halogen gas.

Although claimed not dazzling, but inappropriate use, can interfere with other riders. Basically, HID lights do not dazzle. Condition should be the focus, the selection and adjustment of HID lamps to be precise.

The use of bulb and reflector that quality is not good, will make a focal point of light will split up. In fact, the reflector is designed so as not to dazzle other motorists, with a little design focal point leading to the right (for left wheel cars).

For daily purposes, it is advisable to use the size of 3500K to 6000K with a power of 35-45 watts. The higher the degree Kelvin, just getting down the lamp brightness.

After the high-low and the position of the beam HID lights, very important for lamps provide maximum illumination, without disturbing the view of other motorists. Parameters for determining the adjustment direction of the light is difficult. Because they have to use special equipment, for the right light and no glare falling.

Hid Bulb Construction (Do not be confused positions)
Generally, the output current car uses coded bulb H1, H3, H4, H7 and H11. Broadly speaking, can be classified into two categories, H1 H3, H7 or H4. For bulb H1, H3 and H7, have smaller dimensions and can only be for one suit headlights (low beam only). As for the H4 type has a larger dimension because it has two settings headlights (low beam and high beam).

So when the election until the installation should not be confused, because in addition to the stand will not fit, some mischievous act of an exchange of mechanical construction can make a lamp lights not rigid and risky to make a reflector on fire.

Installation of Ballast (Avoid heat sources)
In one series of HID lights, there is a ballast that serves to raise the 12-volt electrical power to tens of thousands of volts, so the ballast has a vital function. Try ballasts are placed as far as possible from the engine. Because, ballasts cartilage damaged if exposed to hot temperatures. Installation of an ideal ballast generally placed behind the front bumper or in any other part that is not too close to heat source.

Incoming search terms:

• how to install HID
• how to install hid bulbs
• how to install hid bulb
• hid bulb install
• two point hid bulb
• hid bulb installation
• install hid high and low beam bulb
• small hid bulbs
• hid bulb
• installing hid bulb

Tags: Auto, Bulb, Condition, consumption, Discharge, Draft, fire installation, halogen, halogen gas, high intensity discharge, Install, installation, intensity, lamp brightness, light intensity, lighting technology, maximum illumination, standard lamps, technology, use, wheel cars, xenon gas

This entry was posted on May 14, 2011 at 10:58 am. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Posted in Tips by Admin | No Comments Yet